|
<< Click to Display Table of Contents >> Navigation: »No topics above this level« MpJ1939CCVS1Type |
mapp Services V5.16
This data type describes PGN CCVS1 (speed control / vehicle speed 1).
Data type |
Description |
|
EngShutdownOverrideSwitch |
Switching signal indicating the position of the overload switch of the engine shutdown. This switch function allows the operator to override an impending engine shutdown. |
|
EngIdleDecrementSwitch |
Switching signal indicating the position of the engine diagnostic test mode switch. |
|
EngIdleDecrementSwitch |
Switching signal indicating the position of the idle decrement switch. |
|
EngIdleIncrementSwitch |
Switching signal indicating the position of the idle increment switch. |
|
CruiseCtrlStates |
State of the cruise control. |
|
PTOGovernorState |
This parameter is used to indicate the current state or operating mode of the power take-off governor. |
|
CruiseCtrlSetSpeed |
INT |
Speed of the cruise control. |
CruiseCtrlAccelerateSwitch |
Specifies whether cruise control is in position "Accelerate". |
|
CruiseCtrlResumeSwitch |
Specifies whether cruise control is in position "Resume". |
|
CruiseCtrlCoastSwitch |
Specifies whether cruise control is in position "Decelerate". |
|
CruiseCtrlSetSwitch |
Specifies whether cruise control is in position "Set". |
|
ClutchSwitch |
Specifies whether the clutch pedal is depressed. |
|
BrakeSwitch |
Specifies whether the brake pedal is actuated. |
|
CruiseCtrlEnableSwitch |
Specifies whether it should be possible to modify the cruise control. |
|
CruiseCtrlActive |
Specifies whether cruise control is switched on or not. |
|
WheelBasedVehicleSpeed |
REAL |
Speed of the vehicle calculated from the wheel or stern shaft speed. |
ParkBrakeReleaseInhibitRq |
The parking brake release inhibitor request specifies whether the parking brake remains actuated. |
|
CruiseCtrlPauseSwitch |
Specifies the position of the cruise control interrupt switch. |
|
ParkingBrakeSwitch |
Specifies the state of the parking brake. |
|
TwoSpeedAxleSwitch |
Specifies the status of the current axis range. |
|
Status |
State of the parameter group number. |